Haier slim3 Owner's Manual page 23

Front Load Washing Machine
Choose pre-wash program and start ，
Check if there is 220-240V at import pin
of electromagnetic valve
N
Is there open circuit
electromagnetic valve and PCB?
N
Choose pre-wash program and start ，
then check if there is 220-240V at export
pin of electromagnetic valve
Failure:no draining
Troubleshooting:
Is the height of drain pipe too high?
N
Turn filter anticlockwise， open and check if
filter is jammed
N
Check if hose connecting cylinder to pump is
bent or jammed
N
Turn on power and choose spin program to start.
Measure if import voltage of drain pump is
220-240V
N
Cut off and check if the connection between
drain pump and PCB is open
N
Turn on and choose spin program to
start. Measure if export voltage of PCB to
drain pump is 220-240V
Failure :abnormal noise and vibration
Troubleshooting:
Is the pack screws dismantled?
Y
Is there foreign material in the washer?
Y
Y
between
（See fig 2）
Y
Y
Y
（ See fig 1）
N
Y
Model:slim3
Replace electromagnetic valve
Y
Reconnect the wire
Replace PCB
N
Adjust the height of drain pipe to
80-100 cm
Clean and tighten filter clockwise.
Y
Arrange hose and clean
Replace drain pump
Y
Replace the wire.
N
Dismantle the screws
Clean
Replace
PCB
20