Related Manuals for HyperX Clutch
Summary of Contents for HyperX Clutch
- Page 1 HyperX Clutch Part Numbers 516L8AA Document No. 516L8AA.A02 HyperX Clutch Page 1 of 9...
-
Page 2: Table Of Contents
Setup............................5 Charging ..................................5 Mode Selection .................................5 Pairing and Connecting ............................6 Usage ............................7 Calibration ..........................8 Reset ............................8 X-Input & DirectInput ....................... 9 Questions or Setup Issues? ....................9 Document No. 516L8AA.A02 HyperX Clutch Page 2 of 9... -
Page 3: Overview
(L2 / R2) wireless adapter B. Analog sticks E. Mode selection H. USB-C port K. USB-C to switch USB-A cable C. D-Pad F. Bumpers I. Convertible (L1 / R1) mobile clip Document No. 516L8AA.A02 HyperX Clutch Page 3 of 9... -
Page 4: Specifications
75.1mm** Width 155.6mm 41mm – 86mm Mobile clip dimensions Weight (without cable) 270g** Cable type and length Detachable USB-C cable, 2.95m *Battery life varies based on usage **With phone clip installed Document No. 516L8AA.A02 HyperX Clutch Page 4 of 9... -
Page 5: Setup
Setup Charging LED STATUS BATTERY LEVEL ≤ 25% 26% - 50% 51% - 75% 76% - 100% It is recommended to fully charge the controller before first use. Mode Selection Document No. 516L8AA.A02 HyperX Clutch Page 5 of 9... -
Page 6: Pairing And Connecting
2. Press and hold the Home button for 6 seconds until the LEDs animate to indicate pairing mode. 3. On your Bluetooth-enabled device, search and connect to “HyperX Clutch.” 1. Set the mode selection switch to USB. 2. Plug in the USB-C cable into the controller. -
Page 7: Usage
Press and release the Home Button to power the controller. The controller will attempt to connect to the previously paired device. Power Off The controller will automatically shut off after 5 minutes of inactivity. The Clutch can also be manually shut off by toggling the mode selector switch. Handheld Mode... -
Page 8: Calibration
5. Press Y + D-Pad DOWN to save and exit calibration mode. Reset The controller can be manually power cycled by pressing the pin hole button on the rear of the controller. Reset Document No. 516L8AA.A02 HyperX Clutch Page 8 of 9... -
Page 9: X-Input & Directinput
When LED 2 & 4 flash twice and return to normal, the controller is in DirectInput Mode. While in Bluetooth mode, the controller will operate in DirectInput mode and switching between X-Input and DirectInput Mode is disabled. Questions or Setup Issues? Contact the HyperX support team at: hyperx.gg/support Document No. 516L8AA.A02 HyperX Clutch...
Need help?
Do you have a question about the Clutch and is the answer not in the manual?
Questions and answers