Detergent And Rinse Aid - Haier HDW201SS User Manual

Detergent and Rinse Aid

Detergent
Only detergents specifically intended for use with dishwashers must
be used. The dispenser must be filled before the start of each wash
cycle following the instructions provided in the "Wash Cycle Table."
The detergent dispenser is located on the inside panel of the door.
Loading the Detergent
Open the cover "A" on the dispenser, press the button "B". Then
pour the detergent for the wash cycle into the compartment "C".
After the detergent has been loaded, close the cover and press it
down until it clicks into place.
B
Note : Remove excess detergent from the edges of the
dispenser before closing the lid
C
Rinse Aid
This product makes dishes sparkle and helps them to dry without
spotting. The dispenser is located on the inside panel of the door
and should be filled after approximately 80 wash cycles (or when
the rinse aid indicator light comes on for those models with this
feature).
Loading the Rinse Aid
Open the dispenser by turning the cap "C" in an anti-clockwise
direction and pour in the rinse aid. ( Do not overfill ). To regulate the
amount of rinse aid dispensed during each cycle, turn the dose
adjuster "F", located beneath the cap, with a screwdriver. There are
6 different settings; the normal dosage setting is 3.
Important
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs, the
dosage adjustor should be turned to a higher setting. If the dishes
have white streaks, turn the dosage adjustor to a lower setting.
.3.