Advertisement
device working status with a comprehensive simplified
troubleshooting; the function of each LED is described in the
table as below:
LED
Indicate
Description
PWR is connected and running
ON
normally
POWER
(1-2)
PWR is disconnected and
OFF
running abnormally
Blinking
System runs normally
The system is not running or
RUN
OFF
running abnormally
ON
System is running abnormally
Port has established valid
ON
network connection
Port is in a network
Link(1-2)
Blinking
communication status
Port hasn't established valid
OFF
network connection.
No data or abnormal data is
OFF
being transmitted through serial
TX(1-32)
port.
Blinking
Serial port is transmitting data.
Serial port is not receiving data
OFF
RX(1-32)
or receiving data abnormally
Blinking
Serial port is receiving data.
【Logging in to WEB Interface】
This device supports WEB management and configuration.
Computer can access the device via Ethernet interface. The
way of logging in to device's configuration interface via IE
browser is shown as below:
Step 1
Configure the IP addresses of computer and the
device to the same network segment(The
network segment of Network Port 1 is 1, and the
network segment of network port 2 is 8), and the
network
between
them
Step 2
Step 3
Step 4
Note:
The default IP address of the device Network port 1 is
"192.168.1.254", the default IP address of the network port
2 is "192.168.8.254".
"admin".
to factory settings via device DIP switch or management
software; all modified configurations will be cleared after
restoring to factory settings, so please backup configuration
file in advance.
can
be
mutually
accessed.
Enter device's IP address in the address bar of
the computer browser.
Network Port 1:
Network Port 2：
Enter device's username and password in the
login window as shown below.
Click "OK" button to login to the WEB interface of
the device.
The default user name and password of the device are
If the username or password is lost, user can restore it
Please refer to user manual for specific configuration
method of logging in to WEB interface and other
configurations about network management function.
【Specification】
Panel
100M Copper Port
10/100Base-T(X)
self-adapting
half/full duplex self-adapting or
forced working mode, support
MDI/MDI-X self-adapting
Serial Port
3IN1 serial port, adopts RJ45,
supports 15KV ESD protection
Console port
CLI command management
port (RS-232), RJ45
Indicator
Power
status indicator, copper port
connection status indicator,
serial port receiving indicator,
serial
indicator
OLED display
Menu/Exit, page up, page
down, select/confirm
Power Supply
Input power supply
85~265VAC
Access terminal block
Support single-phase socket
with rocker switch
Power Consumption
No-load
5.6W@220VAC
Full-load
13.2W@220VAC
Working Environment
Working temperature
-40～75℃
Storage temperature
-40～85℃
Working humidity
5%～95% (no condensation)
Protection grade
IP40 (metal shell)
RJ45
port,
indicator,
running
port
transmission
Advertisement
