Disassembly Instructions - Mitsubishi Electric MSZ-RW25VG Service Manual

11

DISASSEMBLY INSTRUCTIONS

DISASSEMBLY INSTRUCTIONS
<Detaching method of the terminal with locking mechanism>
The terminal which has the locking mechanism can be detached as shown below.
There are 2 types of the terminal with locking mechanim.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
MSZ-RW25VG MSZ-RW35VG MSZ-RW50VG
NOTE: Turn OFF the power supply before disassembly.
OPERATING PROCEDURE
1. Removing the front panel and the panels (U/R/L/
F) and horizontal vanes (upper R/L), (lower R/L)
Removing the front panel (Photos 1, 2)
(1) Lift the front panel until a "click" is heard.
(2) Hold the hinges and pull to remove the front panel.
Removing the horizontal vanes (upper R/L), (lower
R/L)(Photos 3)
(1) Unlock the rocks of the horizontal vane upper (R)(2
points). Pull and remove the horizontal vane upper (R)
to the side.
(2) Remove the horizontal vane upper (L) and horizontal
vane lower (R) (L) by the same procedure.
OBH902A
(2) The terminal with this connector shown below
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
Photo 1
Screw of the left
side of the panel (U)
Photo 2
Photo 3
46
has the locking mechanism.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
: Indicates the visible parts in the photos/figures.
: Indicates the invisible parts in the photos/figures.
PHOTOS/FIGURES
Horizontal vane
Front panel
upper (L)
Panel (U)
Horizontal vane
lower (L)
Horizontal vane
upper (R)
Catch
Screw of the right
side of the panel (U)
Horizontal vane
lower (R)