Table of Contents
Advertisement
5
6
RS-232 Serial Port
Use a Null Modem cable when connecting to a
PC. When connecting to a multiplexer, it may
be necessary to construct a cable using the pin-
out documentation of the MUX as a guide. See
the pin-out configuration for the DSR-1000eZ
below.
DB-9 Pin Configuration for Serial Port
Pin
1
2
3
Pin 7: Ground.
6: Error Out.
The back panel of the unit is equipped with an Accessories Port (DB-9
style connector). Connect the Accessories PCB (supplied with the unit) to
Do not attempt to wire accessories directly to the DB-9 connector.
the Accessories Port. Wire all accessories to the Accessories PCB.
If the Accessories PCB is lost or missing, contact GE Interlogix Customer
DB-9 Connector on
Service for a replacement (Part Number 0900-0127a). As a substitute,
Back Panel
purchase a female DB
-9 connector and make all connections as shown in
s section.
0150-0238A
5
3 4
1 2
G N D
Use
Pin
DCD
4
Not Connected
RX
5
TX
6
Not Connected
Pin 9:
Disk End Out.
Pin 8: Videoloss Out.
Connector Type: DB-9
Gender (on unit): Male
Cable Required (Connected to PC): Null Modem
Cable Required (Connected to Multiplexer):
Variable, depending on pin-out configuration of
MUX.
Use
Pin
7
Ground
8
Pin 10: Ground.
9
Not Connected
1-5
Video Input an
Use
RTS
CTS
Calibur DSR-1000eZ
6
Advertisement
Table of Contents
