Setting Of Printer - Furuno NX-700B Operator's Manual

Navtex receiver
Hide thumbs Also See for NX-700B:
Table of Contents

Advertisement

4. INSTALLATION
4.6

Setting of Printer

After the connection completely, the setting of printer should be done for
NX-700B as shown below. (For NX-700A, use the default setting as is.)
1. Press the
2. Press the MENU key to show the main menu.
3. Press ▼ to choose System, and then press the ENT key or ► to activate the
System menu.
4. Press ▼ to choose Printer, and then press the ENT key or ► to show the
item window.
5. Press ▲ or ▼ to choose the appropriate setting, and then press the ENT
key.
None: When no printer is connected.
NX-700A: For NX-700A only.
Upright: When NX-700B is connected to an upright-type printer which ejects
Inverted: When NX-700B is connected to a bulkhead mount printer which ejects
6. Press the MENU key several times to close the menu.
4-10
key to turn the power on.
Menu
NAVTEX
System
Display
Service
System
Warn Msg Alm
Signal Monitor
Key Beep
Time Offset
Units
Printer
paper in bottom to top direction.
paper in top to bottom direction.
Off
Off
Off
+00:00
nm, kt
NX-700A
None
NX-700A
Upright
Inverted

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nx-700Nx-700a

Table of Contents