Maintenance; Periodic Maintenance Schedule - Furuno FR-1500 MARK-3 Series User Manual

15" multi-color high-performance shipborne radar and arpa
Hide thumbs Also See for FR-1500 MARK-3 Series:
Table of Contents

Advertisement

5 MAINTENANCE

WARNING
Do not open the equipment
Hazardous voltage which can cause electrical shock exists inside the equipment.
Only qualified personnel should work inside the equipment.
Turn off the radar power switch before servicing the antenna unit. Post a
warning sign near the switch indicating it should not be turned on while the
antenna unit is being serviced.
Prevent the potential risk of being struck by the rotating antenna and exposure to
RF radiation hazard.
Wear a safety belt and hard hat when working on the antenna unit.
Severe injury or death can result if someone falls from the radar antenna mast.
Notice for technicians
The display unit designed to run on AC voltage has a
switch (S2) at its rear to cut off 115/230 V supply from
internal circuits. Turn off the switch when accessing
inside the display unit.

5.1 Periodic Maintenance Schedule

Periodic checks and maintenance are important for proper operation of any electronic systems.
This chapter contains maintenance instructions to be followed to obtain optimum performance and
the longest possible life of the equipment.
Interval
Check point
3 to 6
Exposed nuts
months
and bolts on
antenna unit
Antenna radiator
Check and measures
Check for corroded or
loosened nuts and bolts. If
necessary, clean and repaint
them thickly. Replace them if
heavily corroded.
Check for dirt and cracks on
radiator surface. Thick dirt
should be wiped off with a
soft cloth dampened with
fresh water. If a crack is
found, apply a slight amount
of sealing compound or
adhesive as a temporary
remedy, then call for repair.
-5.1-
Switch S2
Remarks
Sealing compound may be
used instead of paint. Apply a
small amount of grease
between nuts and bolts for
easy removal in future.
Do not use plastic solvent
(acetone) for cleaning. If you
need to remove ice from
antenna unit, use a wooden
hammer or plastic head
hammer. Crack on the unit
may cause water ingress,
causing serious damages to
internal circuits.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fr-1505 mark-3Fr-1510 mark-3Fr-1525 mark-3

Table of Contents