Chapter 5 When You Suspect That A Fault Occurred - Fujitsu M3091DC Operation Manual

CHAPTER
5
When you suspect a fault occurred while using the image scanner, check
the items listed below.
Problem
Power is not Is the AC adapter connected
turned on correctly?
Reading does Are documents inserted to the
not start back of the automatic document
feeder?
Is the automatic document feeder
closed completely?
Is the interface cable connected
correctly?
Is the SCSI terminating resistor
switch set correctly?
M3091DC Image Scanner Operation Guide
When you suspect that a fault
occurred
Item to be Checked Correction
Connect the AC adapter correctly.
Turn off the power once by
disconnecting the AC adapter.
Then, turn on the power again by
connecting the power cable. If the
power is not turned on, notify the
sales agent or the nearest service
center.
Insert the documents gently to the
back.
Confirm that the automatic
document feeder is closed.
Connect the interface cable
correctly.
When the equipment is the end
terminator of SCSI, set the switch
to ON; otherwise, set it to OFF.
5-1