Confirming/Setting The Line Number - Sony HKDW-704 Operation Manual

1

1-3-2 Confirming/Setting the Line Number

It is necessary to set an line number to output the GPS data to be
recorded on a tape to the HD(SD) SDI signal of studio-use equipment.
The data is not output if the line number is set to 00 , the factory setting.
The VANC RX PARAMETER page of the MAINTENANCE menu
allows you to confirm and set the line number for LINE 1 and LINE 2 as
the field where the output line number with be stored. At the factory,
both are preset to 00. If the line number is set to 00, data will not be
output and will not be recorded with the HD (SD) SDI signal.
VANC RX PARAMETER page
LINE 1: Output line number of the first UMID field. You can enter a
number from 0 to 999.
LINE 2: Output line number of the second UMID field. You can enter a
number from 0 to 999.
When it is set to 0, data is not output.
1-10
Chapter 1 Using GPS Data