Sp1 ─ Switch Point 1; Sp2 ─ Switch Point 2; Hys ─ Switch Points Hysteresis; Mean Filter - IFM DP1222 Operating Instructions Manual

Converter 2 x 0...10 V / IO-Link
• High active = status bit is set to "high" (if "High active" activated)
• Low active = status bit is set to "low" (if "Low active" activated)
In operating mode 1, this parameter is not available.
8.1.8 SP1 ─ switch point 1
Threshold for the upper switch point
It always applies: SP1 > SP2
In operating mode 1, this parameter is not available.
8.1.9 SP2 ─ switch point 2
Threshold for the lower switch point
It always applies: SP2 < SP1
In operating mode 1, this parameter is not available.
8.1.10 HyS ─ switch points hysteresis
Setting of the hysteresis with respect to switch points SP1 and SP2: Function diagrams (Ò / 7).
Only active in the switch point modes "Single point mode" and "Window mode".
In operating mode 1, this parameter is not available.
8.1.11 Mean filter
Indicates the time during which the mean value of the measured value is generated. Duration in ms,
min. 5 ms, max. 1000 ms.
DP1222
15