Table of Contents
Advertisement
DP1222
8 Parameter setting
During parameter setting the unit remains in the operating mode. It continues its functions with
the existing parameters until the parameter setting has been completed.
8.1 Parameters via IO-Link
8.1.1 Application-specific tag
Customer-specific application description, max. 32 characters long.
Value: " *** " / can be freely defined by the customer
8.1.2 Function Tag
Customer-specific application description, max. 32 characters long.
Value: " *** " / can be freely defined by the customer
8.1.3 Location Tag
Customer-specific application description, max. 32 characters long.
Value: " *** " / can be freely defined by the customer
8.1.4 internal_temperature – operating temperature microcontroller
Reads the data from the internal temperature sensor of the microcontroller.
In operating mode 1, this parameter is not available.
8.1.5 operation_hours – operating hours
Only counts full operating hours. Operating times of less than one full hour are not saved. Counter
values are saved permanently.
In operating mode 1, this parameter is not available.
8.1.6 ModE ─ switch point mode
Setting of the switch point mode
•
Single point mode (Ò / 7)
•
Window mode (Ò / 8)
•
Two point mode (Ò / 8)
•
Deactivated mode (Ò / 8)
In operating mode 1, this parameter is not available.
8.1.7 LoGc ─ switch point logic
Setting of the switch point logic: Function diagrams (Ò / 7)
14
Converter 2 x 0...10 V / IO-Link
Advertisement
Table of Contents
