Operation - Craftsman C459.62103-2 Operator's Manual

Fuel Cap
Muffler
Air Filter
Choke
Throttle
Pull Starter Handle
Now that you have set up your tiller for operation, get acquainted with
its controls and features. These are described on the next two pages
and illustrated on this page. This knowledge will allow you to use your
new equipment to its fullest potential.
WARNING
The operation of any tiller can result in foreign objects being thrown into
the eyes, which can damage your eyes severely. Always wear safety
glasses during operation or while performing any adjustments or repairs.
RECOIL STARTER HANDLE
This handle is used to start the engine. See Figure 10.
THROTTLE CONTROL
The throttle control is located on the front of the engine. It regulates the
spread of the engine and will shut off the engine when moved into the
STOP position. See Figure 10.
Craftsman Tillers conform to the safety standard of the American National Standards Institute (ANSI).

OPERATION

Reverse Handle
Oil Fill Cap
& Dipstick
Oil Drain
Figure 10
CHOKE CONTROL
The choke control is activated by moving the lever to the CHOKE
position. Activating the choke control closes the choke plate on the
carburetor and aids in starting the engine.
AIR FILTER
The air filter is a device on the engine air intake that prevents dust and
dirt entering the engine. See Figure 10.
MUFFLER
Engine exhaust exits the engine via the muffler. See Figure 10.
REVERSE HANDLE
The Reverse Handle controls the reverse drive of the wheels and the
tines. See Figure 10.
FORWARD CLUTCH BAIL & TINE ENGAGEMENT
The forward clutch bail controls the engagement of the forward drive of
the wheels and tines. See Figure 10.
Meets ANSI Safety Standards
11
Depth Regulator
Handle Height
Adjustment
Side Shield
Tines
Wheel Drive Pin
Forward Clutch Bail
& Tine Engagement
Rear Tine Shield