Selecting Programmes - Silvercrest SLE 200 A1 Operating Instructions Manual

Selecting programmes

The appliance has 2 programmes:
▯ DEHUMIDIFICATION (
▯ FAN (
♦ Press the
selected programme flashes for approx. 5 seconds and is then shown
permanently on the display w.
DEHUMIDIFICATION
This programme allows you to set the desired relative air humidity level that
should be achieved.
♦ Press the
between 30% and 80%. The set value flashes for approx. 5 seconds on the
display w and then the current programme (
You also have the option to select the
humidity below 30%. This setting allows you to achieve a very low relative
humidity as the dehumidification runs permanently.
♦ Press the
NOTE
► Note that the values for the relative humidity have a tolerance of approx. ± 3%
and that there may be a slight delay before the appliance itself/the de-
humidification function switches on or off.
► The minimum humidity that can be achieved in continuous dehumidification
mode (
ambient temperature, etc. Therefore, it is not possible to define a generally
applicable minimum value.
FAN
No dehumidification takes place in this programme. The room air is drawn in
through the air inlet 3, passes through the filter 5 and is discharged back into
the room through the air outlet 7.
Select this programme if you want to circulate but not dehumidify the air in the
room.
SLE 200 A1
)
)
button t repeatedly to select the desired programme. The
button r to set the desired relative humidity in 5% increments
button r repeatedly until
) is dependent on many factors, such as the room size or the
) is shown again.
setting if you want to set the relative
is shown on the display w.
GB │ MT │ 79 ■