Table of Contents
Advertisement
5.
Before starting, turn the power off at the breaker box or switch. Open package to find the
UWP. See Figure 5.
6.
Position the UWP on wall. Level and mark hole positions. See Figure 6.
Drill holes at marked positions, and then lightly tap supplied wall anchors into the wall
using a hammer. ‒ Drill 7/32" holes for drywall.
7.
Pull the door open and insert the wires through wiring hole of the UWP. See Figure 7.
8.
8Place the UWP over the wall anchors.Insert and tighten mounting screws supplied with the
UWP. Do not overtighten. Tighten until the UWP no longer moves. Close the door. See
Figure8.
Power options
Setting Slider Tabs
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Home Pro Series and is the answer not in the manual?
Questions and answers
How to set heat mode from cool mode
what does the permanent or temporary 'hold' mean
We have a Honeywell Home Pro Series thermostat and a gas furnace. Our home was built about 2 years ago. For the last month or so our heat cuts off at times. It was 59 degrees in our home again this morning (****outside). It cuts off occasionally for several hours then works normally for days. We reviewed manual several times but can not find the problem. Suggestions please?
How do I put my thermostat on permanent hold
the unit increases temperature on its own
@robert burchfield
I accidentally locked my Honeywell Pro Series controller. I have no idea what the pin is. Is there a default PIN? Is there a way to reset it?