Table of Contents
Advertisement
Thermostat mounting
1.Push excess wire back into the wall opening.
2. Close the UWP door. It should remain closed without bulging.
3. Align the UWP with the thermostat, and push gently until the thermostat snaps in place.
4. Turn the power on at the breaker box or switch.
System operation settings
1 Press the Mode button to cycle to the next available System mode.
2 Cycle through the modes until the required System mode is displayed and leave it to
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the Home Pro Series and is the answer not in the manual?
Questions and answers
How to set heat mode from cool mode
what does the permanent or temporary 'hold' mean
We have a Honeywell Home Pro Series thermostat and a gas furnace. Our home was built about 2 years ago. For the last month or so our heat cuts off at times. It was 59 degrees in our home again this morning (****outside). It cuts off occasionally for several hours then works normally for days. We reviewed manual several times but can not find the problem. Suggestions please?
How do I put my thermostat on permanent hold
the unit increases temperature on its own
@robert burchfield
I accidentally locked my Honeywell Pro Series controller. I have no idea what the pin is. Is there a default PIN? Is there a way to reset it?