Dual XHDR6435 Installation & Owner's Manual page 26

XHDR6435 OPERATION
Bluetooth
Function
Making a Phone Call
Receiving a Phone
Call
During a Phone Call
Refusing a Call
Ending a Phone Call
Redial
26
Operation (BTM60)
®
Press once. "Enter Number" will be shown, then an "_" will
appear on the display.
Input the desired phone number using the 0-9, *, # buttons on the
remote control. Press
A phone call may also be placed from your mobile device using
the keypad, phone book or speed dial. When a call is placed from
a mobile device, "DIALING" will appear on the head unit display.
If an incoming call is detected, the head unit will automatically
switch to Bluetooth mode.
The incoming phone number will scroll across the display, the
phone icon will flash on the display, and a ring tone will be
audible from the vehicle speakers. See Bluetooth Settings for
speaker configurations.
Note: The ring audio level will depend on the mobile device and
head unit ring volume and audio settings. If the ringer on the
mobile device is off, you may not hear an incoming ring tone.
Press on the head unit to receive a call. The phone icon in the
display will illuminate solid.
The head unit will display the elapsed time of the phone call.
The volume knob will adjust the volume of the call.
Press MUTE to mute the microphone during a call.
To refuse an incoming phone call, press and hold
seconds.
Press to end a call.
If the phone call was received, the head unit will return to
previous mode when call is ended.
Press twice consecutively to redial the last number.
Description
to begin dialing.
for 3