Communication With Pc; User Outputs - Elen B1 Series User Manual

2.6. Communication with PC

RS232
You can monitor the UPS over RS232 port using UPSilon2000 software that you will
install on your computer (this is optional and therefore UPS software and RS232 cable
must be ordered prior to use of this option). Using this software, you can monitor real-
time UPS voltage and current information, battery information, malfunctioning warnings,
etc. and save long term logs with graphics. In addition, software shuts down your
computer and/or server safely in case of any electrical power outage.
SNMP
SNMP (Simple Network Management Protocol) is an advanced communication protocol.
Using SNMP, multiple UPSs can be synchronously monitored and managed from a
single common center. SNMP can be connected to a computer or a network over an
'Ethernet' communication port. An IP (Internet Protocol) number assigned to SNMP is
used to connect to a UPS from anywhere on the network and monitor real time operation
information, save long term logs, carry out testing, and turn on/off the UPS or the server.

2.7. User Outputs

When you use the UPS in environments where the UPS cannot be under consistent
surveillance, you can have remote signals for power outage, audibly or visually. Using
the outputs mentioned on a simple bell, siren or light circuit, the mains voltage and the
battery capacity can be monitored. In this way, loads can be protected by being safely
shut down.
Page | 12 –
B1 10kVA V1.0.1
Figure 2.9 SNMP Communication
Figure 2.10 User Outputs