Lindy 39540 User Manual page 5

User Manual
Operation
This KVM switch features two methods of switching between sources: push button and hotkeys.
Front Panel Push Button
Press the appropriate port button on the front panel for manual switching. The switching will be
confirmed by a beep and the PC LED will illuminate green. By default, PC port, USB hub and audio
switching are bound together, the binding of the hub and other switching options like Autoscan, disabling
the beep sound and changing default hotkeys can be changed with keyboard hotkeys (see below).
Keyboard Hotkeys
Hotkey commands can be activated by pressing the default leading code "Scroll Lock" + "Scroll Lock"
within 2 seconds.
Hotkey
Leading code + 01~08
Leading code + ↑ or ↓
Leading code + ←
Leading code + Z
Leading code + X
Leading code + B
Leading code + S
Leading code + S + (z)
z= 0~9
Leading code + H + F12 /
Num Lock / Caps Lock /
Scroll Lock
*Please Note: it is possible to change the default hotkey also by pressing and holding down button 8 until
hearing two beeps, then release the button and press one from F12, Num Lock, Caps Lock and Scroll
Lock key.
Function
Switch to the selected port number.
Switch to the next or previous.
Toggle between the previous port and current port.
Enable the binding of PC port and hub port control switching (enabled by
default).
Disable the binding of PC port and hub port control switching.
Disable/Enable beep sound (enabled by default).
Start Autoscan with default delay (10 sec.).
Press any button to stop Autoscan.
Start Autoscan and set up scan delay withing a range of 10~100 sec.:
1= 10"; 2= 20"; 3= 30"; 4= 40"; 5= 50"; 6= 60"; 7= 70"; 8=80"; 9= 90";
0=100".
Press any button to stop Autoscan.
Change default hotkey choosing one from F12, Num Lock, Caps Lock and
Scroll Lock*.
English