Set-Up Lower Contour Roller Adjustment - Demtech Pro-Wedge VM-20 Operator's Manual

Rev. F, December 2020
7.3

Set-up Lower Contour Roller Adjustment

Location:
The lower contour rollers (#3 and #4, Figure 6) are located below the heating wedge
and are mounted to the lower frame directly in front of the lower nip roller (#2,
Figure 6). For this adjustment you will need a 13mm open end wrench and a 4mm and
6mm Allen wrench.
With the nip pressure lever in the up position and the wedge in the disengaged
position, insert the adjustment material that you cut earlier from the template into
the Pro- Wedge as shown in Figure 6 above:
Make sure the word "Top" is facing up then slide the material above and below
the wedge and between the upper and lower contour rollers as shown above. Insert
just enough in so that about 2 ¾" (70mm) of material is protruding out of the nip
rollers from the point where the nip rollers pinch down on the material. Slide the
wedge to its engaged position until it locks into its detent. Then lock the nip
pressure lever down on to the material.
Pro-Wedge VM-20 Operator's Manual
10
4
3
Figure 6
6
5
2
Page 14