Installing Pci-Express / Pci-X Card; Installing The Hard Drive Tray Modules - CalDigit HDPro User Manual

Installing the PCI-Express / PCI-X Card
Your HDPro comes with a PCI-Express / PCI-X card. You must have this card properly installed in your computer in
order for your computer to work with the HDPro Storage System.
1. Turn off your computer and unplug the AC cord, attached to wall or power strip, etc.
2. Remove the cover of your computer and locate an available PCI-e / PCI-X slot on the motherboard & install the
required PCI-Express / PCI-X card.
Important Note: Many motherboards only come with 1 PCI-Express / PCI-X interface. For more information, please
check your motherboard's user manual.

Installing the Hard Drive Tray Modules

Note: Your HDPro is shipped with the drive modules packaged separately to prevent damage.
1. Examine the corresponding drive number on the hard drive label; slide tray drives into the HDPro.
2. After drive has been installed, check & make sure the drive lever is locked.
3. Repeat with the other drives.
4. Close the hard drive door, and tighten the thumbscrews.
Hard Drive Door
Thumbscrews
Hard Drive
Tray Lever
9
9