Eagle G009MT Instructions

1m (2x 500mm) RGB USB
CONGRATULATIONS ON YOUR PURCHASE
Thank you for purchasing this Eagle Tape Light Kit. Please read these instructions carefully
and leave with the user of the product for future reference. If the product is sold on then the
instruction/manual should pass on as well.

BEFORE USE

You must inspect the product and all accessories including any cables or leads for any signs of
damage. If the product is damaged, DO NOT use it, and contact your supplier immediately.

PRODUCT SAFETY

• Children shall not play with the unit.
• Cleaning and user maintenance shall not be made by children without supervision.
• Disconnect from its power supply when not in use
• Do not leave this device switched on when unattended.
• Keep away from moisture and sources of heat.
• For indoor use only.
• Periodically check this product for damage. If any is detected do not use and contact your
supplier.
• Only use this product with 5V approved USB outputs (not provided) Rated at 0.2A (1W) or
above.

OPERATION and INSTALLATION

• Installation must take place whilst the unit is unplugged
• The product MUST NOT be mounted using staples, nails, or metal fixings.
• The product can be installed in the desired location simply by removing the self-adhesive
backing on the rear of the tape light and then pressing the tape light against a smooth clean
surface. The surface must be free of dust and grease.
• Apply firm pressure along the length of the tape light to ensure it has adhered in all locations.
• Once installed, plug the product into its USB power supply (not supplied) and switch on.
• Ensure the product is switched off when not in use.
G009MT
TV Mood Light