Download Print this page

Troubleshooting - Hyundai K2F57 AC000 Manual

Remote engine start - key start for hyundai venue 2020

Advertisement

Function Check
Issue / Concern
1. Press
button one time.
(All doors, hood & trunk are closed).
1. Press
button 2 times.
2. Press
button 2 more times.
1. Press
button one time.
2. Within 3 seconds, press and hold
While the vehicle is running via remote start,
1. Press
button two (2) times.
2. Press
button two (2) additional times.
While the vehicle is running via remote start,
1. Press
button one (1) time.
While the vehicle is running via remote start,
1. Press brake pedal.
While the vehicle is running via remote start,
1. Press and hold
button for two (2) seconds.
While the vehicle is running via remote start,
1. Open the hood.
While the vehicle is running via remote start,
1. Open any door.
While the vehicle is running via remote start,
1. Open trunk(or tailgate).
1. Open trunk(or tailgate).
2. Try to engine remote starter.

Troubleshooting

Item to be Checked
The vehicle does not LOCK by using the Remote Start Key Fob.
The vehicle LOCKS, UNLOCKS, but does not START (no cranking sound).
The vehicle LOCKS, UNLOCKS, but does not START and there is
CRANKING sound from the engine.
The remote does NOT LOCK / UNLOCK and does not START the vehicle.
The Remote LED lights flash when buttons are pressed.
The vehicle lights are not blinking 2 (two) times after engine has been
remotely started.
The LED icon lights on the Transmitter Fob does not light up.
The Engine turns off when entering the vehicle, while running under Remote
Start mode.
Engine does not turn off immediately when the brake pedal is pressed
after starting engine with remote.
The horn does not sound even though hood is open when engine has been
started remotely.
Genuine Accessories
Transmitter Fob LOCK icon will flash, vehicle signal lights will flash, and all
doors will LOCK.
Transmitter Fob UNLOCK icon will flash, vehicle signal lights will flash, and
Driver's door will UNLOCK.
Transmitter Fob UNLOCK icon will flash, vehicle signal lights will flash, and
all doors will UNLOCK.
Transmitter Fob LOCK icon will flash, vehicle signal lights will flash, and all
doors will LOCK.
button for 2 seconds.
Transmitter Fob KEY icon will flash, the engine will crank and start, the
vehicle signal lights will flash.
Transmitter Fob UNLOCK icon flash, vehicle signal light flashes twice
and Driver's door will UNLOCK.
Transmitter Fob UNLOCK icon flash, vehicle signal light flashes twice
and All doors will UNLOCK.
Transmitter Fob LOCK icon will flash, vehicle signal lights will flash, and all
doors will LOCK.
The engine will shut down immediately.
Transmitter Fob KEY icon will flash, and the engine will stop.
The engine will stop.
The engine will stop after approximately thirty (30) seconds.
The engine will stop after approximately fifty (50) seconds.
The horn will sound five (5) time.
Check the vehicle status
1. Engine is OFF.
2. Accessory function is OFF.
3. All doors are closed.
4. Hood and tailgate are closed.
Ensure the Valet Mode is OFF.
(Refer to Owner's Guide for details.)
Ensure that the buttons are properly activated.
Buttons may not recognize a command if the LED icon light is
flashing.
The installation might be faulty.
Call Technical Support on Page 1.
Check that the vehicle battery is not dead.
The installation might be faulty.
Call Technical Support on Page 1.
The Transmitter Fob is not paired to the Control Module.
Follow the Remote Start Fob Pairing Procedure in the
Installation Instructions.
Verify the Relay Module is correctly installed.
(Please refer to Step 16)
The Transmitter Fob batteries are dead.
Refer to the Owner's Guide for instructions to change the batteries.
Vehicle will shut off automatically after thirty (30) seconds, if key is not
in IGN ON position, as noted in the Owner's Guide in the "Driving Off"
section.
Verify the key is in the ignition ON position within 30 seconds after opening
the doors.
Verify the brake pedal is pressed after the key is in ignition ON position.
Verify Driving OFF Mode after remote starting. Engine does not turn off after
Driving Off Mode even when the brake pedal is pressed.
Verify the Relay Module is correctly installed.
(Please refer to Step 16)
Revision Date
06/05/2020
Items to be Checked
Result
Page 12 of 13

Advertisement

loading