Force; Instant - Teletek electronics LED63VG Quick Start Manual

Manager Level Pro-
gramming
As a rule of thumb you can enter
user programming mode using the
following procedure:
Step 1: Enter valid user code
Step 2: Press once
PRG
Step 3: Enter a parameter num-
ber (two digits - see address table)
Step 4: Change parameter value
Step 5: Press to confirm
ENT
and to reject changes.
CLR
A blinking RDY1 LED indicates that
the system is in programming
mode.
Voice Guide Keypad - LED63VG User Manual
Manager Code Change
The manager is required to enter
his current personal code before
changing it.
Manager code change key se-
quence:
C O D E
0
PRG
(2 beeps)
0
The manager can switch between
code change mode and remote ac-
cess permissions mode with the
and keys.
The system is originally in change
code mode.
LEDs 3, 4, 5 and 6 light up to indi-
cate the number of code digits left
to be entered.
The manager is expected to enter
the new code.
Key sequence for entering new
manager code:
NEW
(4 digits)
CODE
NEW
beeps) (reenter)
CODE
16

Force

Force arming means the system is
armed although in (a) certain
zone(s) there may be obstacles or
troubles.
Forced arming key sequence:
CODE
Quick forced arming key se-
quence:
2
ARM
The BPS LED lights up and the LED's
corresponding to the numbers of
the zones which are not armed,
blink slowly.
(2
9

Instant

Instant arming means the user is
allowed to stay in certain zone(s),
but the entrance zone is secured.
The difference with the stay arm-
ing is that intrusion into the en-
trance zone immediately sets on
the alarm.
2
ARM
Instant stay arming key se-
quence:
CODE
Quick instant stay arming key
sequence:
ARM
The BPS LED lights up and the LEDs,
corresponding to the numbers of
the zones, which are not armed,
blink slowly.
Voice Guide Keypad - LED63VG User Manual
3
ARM
3