Page 1
Operation and Maintenance Manual XLP-Series 25 ton Workshop Presses Document Number: L4611 Document Revision: A Issue Date: 14-JAN-2022 Language: English EN To reduce the risk of injury, user must read and understand this document before use.
Page 3
For additional information, visit www.enerpac.com. WARRANTY Refer to the Enerpac Global Warranty document for terms and conditions of the product warranty. Such warranty information can be found at www.enerpac.com. NAMEPLATE Refer to the nameplate decal for the press model number. Decal appearance and text may vary depending on location of product manufacture.
Failure to observe and comply with the following tags, or decals. In the event that any questions or precautions could result in death or serious personal concerns arise, contact Enerpac or a local Enerpac injury. Property damage could also occur. distributor for clarification.
CE and UKCA. pressure. • Never attempt to connect or disconnect hoses while Enerpac declares that the product(s) have been tested the pump is on and/or the system is pressurized. and conforms to applicable standards and the product(s) • Before use, be certain that all hose couplers are are compatible to all EU and UK Requirements.
5. Installation 5.1 Assembling the Press Frame Notes: • Threaded NPT and NPTF connections: Apply PTFE Assemble press legs to press using press leg fasteners tape to male threads and tighten each item to 1.5 to 3 supplied. turns past finger tight (minimum of 40 ft-lbs Assemble winch handle to the winch using hardware [54.2 Nm] ).
6. Operation 6.1 System Set-Up 6.6 Bed Adjustment (Raising and Lowering) WARNING Check all press set-ups and load fixtures for safe operation. WARNING Remove all items from the press bed/ Center the work piece and all parts of the set-up on bolster before raising or lowering bed/bolster.
7. Storage 7.1 Recommended Storage Enerpac tools should be stored in a cool, dry place. Tools should always be cleaned, serviced and lubricated prior to storage. Ensure that tools are stored in their designated packing cases. 8. Maintenance 8.1 Hydraulic System 8.2 Press Frame...
9. Troubleshooting The information in the Troubleshooting Guide is intended as an aid to help diagnose and correct various possible problems that may occur. For repair service, contact your nearest Enerpac Authorized Service Center. Troubleshooting Guide Problem Possible Cause Action...
Decal, Caution* Enerpac V-Block Kit* VB25 VB25 VB25 VB25 * not shown Indicates items included and available only as part of Label Kit, XLP25LK Optional accessory. Two V-blocks are included in each Kit. Order as required...
Need help?
Do you have a question about the XLP Series and is the answer not in the manual?
Questions and answers