Table of Contents
Advertisement
User Manual EtherCAT Slave / BACnet Slave
Document code: MN67E06_ENG
Revision 1.000
Page 12 of 30
Industrial Electronic Devices
ETHERNET:
The Ethernet port is used for programming the device and for BACnet/IP communication.
The updating of the converter must be made using Connector8 of the HD67E06-xxx-A1 with at least a Category 5E cable. The maximum
length of the cable should not exceed 100m. The cable has to conform to the T568 norms relative to connections in cat.5 up to 100 Mbps. To
connect the device to an Hub/Switch is recommended the use of a straight cable, to connect the device to a PC/PLC/other is recommended
the use of a cross cable.
ADFweb.com S.r.l.
Advertisement
Table of Contents
Need help?
Do you have a question about the HD67E06-IP-A1 and is the answer not in the manual?
Questions and answers