Installing The Water Line; Reversing The Door Swing; Important Notes; Tools You Will Need - GE GTH22SBSSS Owner's Manual & Installation Instructions

INSTALLING THE WATER LINE

11 PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator or against the
wall. Push the refrigerator back to the wall.
START THE ICEMAKER
Power switch models – Set the icemaker power
switch to the I (on) position. The icemaker will
not begin to operate until it reaches its operating
temperature of 15°F (–9°C) or below. It will then
begin operation automatically if the icemaker
power switch is in the I (on) position, and the
green light will come on.
Power
Switch
Green Power
Light
Power switch model

REVERSING THE DOOR SWING

IMPORTANT NOTES

When reversing the door swing:
• Read the instructions all the way through before
starting.
• Handle parts carefully to avoid scratching paint.
• Set screws down by their related parts to avoid using
them in the wrong places.
• Provide a non-scratching work surface for the doors.
IMPORTANT: Once you begin, do not move the
cabinet until door-swing reversal is completed.
These instructions are for changing the hinges from
the right side to the left side—if you ever want to change
the hinges back to the right side, follow these same
instructions and reverse all references to left and right.
Unplug the refrigerator from its electrical outlet.
Empty all door shelves, including the dairy
compartment.
Installation Instructions
Icemaker
Feeler Arm
(CONT.)
START THE ICEMAKER (CONT.)
Feeler arm models – Move the feeler arm to the
ON (down) position. The icemaker will not begin to
operate until it reaches its operating temperature
of (15 F) (-9 C) or below. It will begin operation
automatically if the icemaker feeler arm is in the
ON (down) position.
Feeler Arm in the ON
(down) position
NOTE: In lower water pressure conditions, the
water valve may turn on up to 3 times to deliver
enough water to the icemaker.

TOOLS YOU WILL NEED

Phillips screwdriver
Putty knife or
thin-blade screwdriver
3/32" Allen wrench supplied
for use on Stainless steel
refrigerator handles
18
Feeler Arm in the
STOP (up) position
Feeler arm model
5/16" Head socket driver
3/4" Head socket driver
(a 6-point socket is
recommended)
Masking tape
3/16" Allen wrench supplied for
changing handle fasteners location