Thales Datacryptor Ethernet User Manual page 26

Connecting to Datacryptor Ethernet Units
2. Open a terminal session through a VT-100 terminal emulation program such as
HyperTerminal. Enter the connection name, the appropriate serial port (usually COM1 or
COM2), and the following serial port parameters:
Serial Port Parameter
Baud Speed
Parity
Data Bits
Stop Bits
Flow Control
3. Switch on the Datacryptor unit.
4. As the unit boots the message CONFIG STARTUP Y/N will be shown and all the units
LEDs will be lit.
5. Press Y the unit will respond by displaying a short banner and the prompt IPCONFIG>.
6. At the command prompt, type Help for a list of commands available.
Command
HELP
HELPKEYS
DEFAULT
DISPLAY
IPFORWARD
ROUTE
SET
SETTIME
SHOWLOG
VERSIONS
EXIT
Before setting the Management port's parameters, you may want to read the
Note:
Management tab
Page 26
All manuals and user guides at all-guides.com
Value
115,200
None
8
1
None
Description
Display help for a command
List of keyboard usage in this command interface
Return all IP address and net mask settings to defaults.
Display current IP address and net mask settings
Enable or disable IP forwarding
Add, delete, or display IP routing data
Set an IP address and net mask settings
Display or set the unit time (Un-commissioned Datacryptor
Ethernet unit)
Basic display of log contents
Display version numbers of application and bootstrap
Exit the process and reboot the unit if a parameter has been
changed, or just exit if no changes have been made.
section for some background knowledge on their values.
Datacryptor Ethernet User Manual
IP
THALES