GE GBSC0HBX Owner's Manual And Installation Instructions page 16

Models 20, 22 and 23
Hide thumbs Also See for GBSC0HBX:
Table of Contents

Advertisement

Available languages

Available languages

INSTALLING THE REFRIGERATOR
CONNECTING THE REFRIGERATOR TO
1
THE HOUSE WATER LINE
(cont.)
If you are using copper tubing, place a
A
compression nut and ferrule (sleeve) onto the
end of the tubing coming from the house cold
water supply.
If you are using the GE SmartConnect
tubing, the nuts are already assembled to
the tubing.
B
If you are using copper tubing, insert
the end of the tubing into the refrigerator
connection, at the back of the refrigerator,
as far as possible. While holding the tubing,
tighten the fitting.
If you are using GE SmartConnect
insert the molded end of the tubing into the
refrigerator connection, at the back of the
refrigerator, and tighten the compression
nut until it is hand tight. Then tighten one
additional turn with a wrench. Overtightening
may cause leaks.
Fasten the tubing into the clamp provided to
C
hold it in position. You may need to pry open
the clamp.
One of the illustrations below will look like
the connection on your refrigerator.
Icemaker-Ready models
Tubing
Clamp
1/4
Compression
Nut
Ferrule
(sleeve)
Refrigerator
Connection
SmartConnect
Tubing
Icemaker-Installed Models
Ferrule
Refrigerator
(sleeve)
Connection
SmartConnect
Tubing
Installation Instructions
tubing,
1/4 Copper
Tubing
1/4
Compression
Nut
1/4 Tubing
Tubing Clamp
(cont.)
TURN ON THE WATER SUPPLY
2
(icemaker models)
Turn the water on at the shutoff valve (house
water supply) and check for any leaks.
PLUG IN THE REFRIGERATOR
3
On models with an icemaker, before plugging in
the refrigerator, make sure the icemaker power
switch is set to the O (off) position.
See the grounding information attached to the
power cord.
PUT THE REFRIGERATOR IN PLACE
4
Move the refrigerator to its final location.
LEVEL THE REFRIGERATOR
5
Adjustable legs at the front corners of the
refrigerator should be set so the refrigerator is
firmly positioned on the floor, and the front is
raised just enough that the door closes easily
when opened about halfway.
To adjust the leveling legs, turn the legs
clockwise to raise the refrigerator,
counterclockwise to lower it.
16

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents