Control Knobs; Vent Filter And Chamber - GE Profile PP989SNSS Owner's Manual & Installation Instructions

Care and cleaning of the cooktop.
Be sure electrical power is off and all surfaces are cool before cleaning any part of the cooktop.
Shaped area
10
How to Remove Protective Shipping Film and Packaging Tape
Carefully grasp a corner of the protective
shipping film with your fingers and slowly
peel it from the appliance surface. Do not
use any sharp items to remove the film.
Remove all of the film before using the
appliance for the first time.
Vent Grille
Before cleaning the vent grille, be sure
the exhaust blower is turned off.
To clean the vent grille, remove it from
the cooktop by lifting it up and off.
Wipe with a damp cloth. If necessary,
the vent grille can be washed in the sink.

Vent Filter and Chamber

The filter is held in place at an angle with
a hold bump. Lift the filter up and out of
the vent opening diagonally.
To clean the filter, swish it in hot, soapy
water. Rinse well and dry thoroughly.
Do not operate the vent without the
filter in place.
Remove and replace the filter diagonally through the vent
opening.
To order filters please call our toll-free number:
National Parts Center...........800.626.2002
Filter..........................................# WB02X10651

Control Knobs

The control knobs may be removed for
easier cleaning.
Make sure the knobs are in the OFF
positions and pull them straight off the
stems for cleaning.
Stainless Steel Surfaces
Do not use a steel wool pad; it will
scratch the surface.
To clean the stainless steel surface,
use warm sudsy water or a stainless steel
cleaner or polish. Always wipe the surface
in the direction of the grain. Follow the
cleaner instructions for cleaning the
stainless steel surface.
To assure no damage is done to the finish
of the product, the safest way to remove
the adhesive from packaging tape on new
appliances is an application of a household
liquid dishwashing detergent. Apply with a
soft cloth and allow to soak.
NOTE: The adhesive must be removed
from all parts. It cannot be removed if it is
baked on.
Use dishwashing liquid for cleaning.
Do not use abrasive cleaners. They will
damage the vent grille's finish.
Do not clean the vent grille in the
dishwasher.
Do not operate the vent without the
filter in place.
Vent Filter
Vent Chamber
When replacing the filter, make sure it rests, at an angle,
on the supports in the vent opening.
To clean the vent chamber, use hot,
soapy water. Rinse with clean water and
dry thoroughly. Do not use abrasive
cleaners; they will damage the finish.
Replace the filter after it is cleaned and dry.
To clean the knobs, place them in a
dishwasher or wash with soap and water.
Rinse with clean water. Make sure the
insides of knobs are dry before replacing.
Replace the knobs in the OFF position
to ensure proper placement.
(on some models)
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer nearest you, please call
our toll-free number:
National Parts Center
ge.com
1.800.626.2002