Error Message Chart - Canon D1 User Manual

Error Message Chart

Perform the required remedies according to the error indicated on the host machine (printer).
E
B
1
C2
Cause of Error
The delivery section cover is open.
The front cover is open.
The trim unit is not inserted correctly.
The trimmer booklet waste tray is not
inserted correctly.
*1
The conveyor is full.
The trimmer booklet waste tray is full.
A booklet jam has occurred in
tion.
A booklet jam has occurred in
tion.
A booklet jam has occurred in
tion.
A booklet jam has occurred in
tion.
Booklet waste exists at delivery section.
*1
If this error message appears when the conveyor is not full, trim may exists at the sensor.
2
A
C4
C3
3
C1
Close the delivery section cover
Close the front cover
Hold the handle
end correctly.
Insert the trimmer booklet waste tray
correctly.
Lift the
veyor.
Open the front cover
waste tray
let waste tray
D sec-
Open the front cover
from the space on the trim unit. Then close the front cover
to restart the printing.
1
C sec- Open the front cover
dle clockwise to transport the jammed booklet to the trim
unit completely, then hold the
trim unit. Open the
and remove the jammed booklet. Reposition the
and
reposition the trim unit. Then close the front cover
restart the printing.
B sec- Open the front cover
Remove the jammed booklet, reposition the
belt unit and the front cover
A sec- Lift the
pletely. Open the delivery section cover
transport belt unit. Remove the jammed booklet, close the
A transport belt unit and the delivery section cover
to restart the printing.
D
When removing jammed booklets
from the trim section, take care not
to touch the blade edge.
Remedy
.
1
C2 and i nsert the trim unit to the rear
E handle and remove the booklets from the con-
1 , pull out the trimmer booklet
, and empty it. Reposition the trimmer book-
3
and close the front cover
3
and remove the jammed booklet
1
1 and turn the
C3 and
C4 transport belt unit and hold the
1 and the
E handle and remove the jammed booklet com-
CAUTION
.
2
to the rear end
3
1 .
C1 manual han-
C2 handle to pull out the
C4 transport belt unit,
C2 handle to
1
B transport belt unit.
B transport
1 to restart the printing.
2 and the
Error Messages
C3
to
A
2
3-3