Specifying The Parameters Of A Scan - Canon MF6500 Series Driver Manual

Introduction
1
Scanning a
Document 2
Troubleshooting
3
Appendix
4
Table of Contents
Index
Advanced Mode Toolbar
(Clear) Deletes the preview image from the preview
area. It also resets the toolbar settings and
color settings.
(Crop) Specifies the parameter of a scan.
(Move) Moves the enlarged image on the screen.
(Zoom) Enlarges or reduces the preview image.
Click on the image to zoom in, and right-click
on the image to zoom out.
(Left Rotate) Rotates the image 90 degrees left.
(Right Rotate) Rotates the image 90 degrees right.
(Information) Lists the scanning information.
(Auto Crop) Crops the image automatically. For details,
see "Specifying the Parameters of a Scan"
on this page.
(Remove Removes the selected cropping frames.
Cropping
Frame)
Back Previous
[Select All Crops] When this button is used, all the cropping
frames reflect the settings made on the
[Advanced Mode] tab sheet.
[Zoom] Click this button to rescan the focal cropping
area of the preview image at a higher level of
magnification.
Once clicked, this button changes into
[Undo]. The image retunes to its original size
by clicking [Undo].
■

Specifying the Parameters of a Scan

You can create scan areas (cropping areas) for images shown in
the preview area. When you click [Scan], only the cropped area
will be scanned.
NOTE
Crop feature is invalid when [ADF (2-sided)] is selected in [Original
Input Method] on the [Advanced Mode] tab sheet.
Selecting the Cropping Area Automatically
After previewing, click (Auto Crop) on the toolbar. Clicking
this button enables you to gradually crop off the image outside
the borders detected in the preview image.
TOP
Next
2-25