Power; Moving The Scanner - Canon IMAGE FORMULA DR-6010C User Manual

Chapter 1 Before Using the Scanner
• Avoid exposing the scanner to rapid changes in temperature. If the room in which the scanner is
installed is cold but rapidly heated, water droplets (condensation) may form inside the scanner.
This may result in a noticeable degradation in scanning quality.
The following conditions are recommended for optimal scanning quality:
Room temperature:
Humidity:
• Avoid installing the scanner near equipment that generates a magnetic field (e.g. speakers,
televisions, or radios.)

Power

• Connect only to a power outlet of the rated voltage and power supply frequency. (120 V, 60 Hz or
220-240 V, 50/60 Hz depending on your region)
• Do not use a power supply that is not rated for the specified voltage. Doing so might cause a fire or
electric shock.
• Do not connect other electrical equipment to the same power outlet to which the scanner is
connected. Also, when using an extension cord, make sure that the extension cord is rated for the
current requirements of the scanner.
• The power cord may become damaged if it is often stepped on or if heavy objects are placed on it.
Continued use of a damaged power cord can lead to an accident, such as a fire or electrical
shock.
• Do not use the power cord while it is coiled.
• Do not pull directly on the power cord. When disconnecting the power cord, grasp the plug and
remove it from the outlet.
• Keep the area around the power plug clear of objects so that the power cord can be disconnected
easily in an emergency.
• If you have any questions regarding the power supply, contact your local authorized Canon dealer
or service representative for further information.

Moving the Scanner

• When moving the scanner, always hold it with both hands to avoid dropping it. The scanner weighs
approximately 14.3 lb (6.5 kg).
CAUTION
Make sure to disconnect the interface cable and power cord when moving the scanner. If the
scanner is transported with these items plugged in, the plugs and connectors may be
damaged.
10 °C to 32.5 °C (50 °F to 90.5 °F)
20% to 80% RH
1-2