Checking The Filters In The Wash Cabinet; Cleaning The Filters - Miele PFD 101 Operating Instructions Manual

Commercial dishwasher
Hide thumbs Also See for PFD 101:
Table of Contents

Advertisement

Checking the filters in the
wash cabinet
The filter combination in the base of the
wash cabinet retains coarse soil from
the suds solution. This prevents soiling
getting into the circulation system and
re-entering the wash cabinet through
the spray arms.
Damage due to soiling entering
the circulation system.
Without filters, soiling can enter the
circulation system and cause a
blockage.
Do not run a wash program without
the lower spray arm or without the fil-
ters.
When cleaning the filters and spray
arms, make sure that coarse soiling
cannot get into the circulation sys-
tem.
The filters can become blocked by soil-
ing that collects over time. The level of
soiling and time it takes before the fil-
ters need cleaning will vary depending
on use.
The message
Check filters
the display after every 50 program se-
quences.
 Check the filter combination.
 Clean, if necessary.
 Then confirm the message with OK.
will appear in
Cleaning and care

Cleaning the filters

 Turn off the dishwasher.
 Remove the lower spray arm (see
"Cleaning the spray arms" under
"Cleaning and care").
 Before removing the filter combina-
tion, remove any coarse soiling to
prevent it from entering the circulation
system.
 Remove the filter combination.
65

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pfd 101 uPfd 101iPfd 102i

Table of Contents