4 . Touch oven modes,scroll to and touch Steam
clean.
5 . Touch Start .
6 . The time the Steam Clean cycle will end is
shown in the display . Do not open the door
during this time . If door is open while in Steam
Clean (d-O) will appear in the display .
7 .
When the steam clean cycle is complete an
alert will sound and the Off message will show
in the display . Press off to return to the clock .
8 . Take care opening the door when the steam
clean is finished . Stand to the side of the oven
out of the way of escaping vapor .
9 . Wipe oven cavity and bottom . Do not clean
oven door gasket (Figure 8) . Avoid leaning or
resting on the oven door glass while cleaning
cavity .
figure 11: clean around the oven door gasket
SettInG oVen controLS
notes:
•
Opening the oven door during the steam clean
cycle prevents the water from reaching the
temperature needed to clean .
•
For best results, clean oven immediately after
the cycle is complete . Steam clean works best
for soils on the oven bottom .
•
A non-abrasive scouring pad, stainless steel
sponge, plastic scraper, or eraser style cleaning
pad (without cleaner) can be used for difficult
soils . Moisten pads with water before use .
•
Place a paper towel or cloth in front of the
oven to capture any water that may spill while
wiping out .
•
Do not leave the residual water in the oven for
any length of time .
•
Some condensation or water vapor may appear
close to the oven vent and the oven door glass .
This is normal . The oven gasket may become
damp; do not wipe dry .
•
Local water sources often contain minerals
(hard water) . If hard water deposits occur, wipe
cavity with a 50/50 solution of water and vine-
gar or 50/50 solution of lemon juice and water .
•
Steam clean cannot be programmed with a
delayed start time .
•
If Steam Clean results are not satisfactory, run a
Self Clean . See "Self Clean" on page 40 .
43