Advertisement
Siemens Energy & Automation, Inc.
Bellefontaine, OH 43311 U.S.A.
2 of 5
Page
Installation Instructions
4. Remove the line and load terminal shields (see
Fig. 4) by loosening the shield screws that at-
tach them to the circuit breaker.
5. Position the circuit breaker on the mounting
surfaces, install the mounting hardware and
tighten securely.
6. After mounting the circuit breaker, the line and
load terminal accessory terminals should be
connected.
7. After the circuit breaker is installed, check all
mounting hardware for secureness. Check
wire connectors for correct torque require-
ments. Torque values for line and load con-
nectors are provided on the circuit breaker
nameplate.
1.25
9.75
4.40
OF HANDLE
ESCUTCHEON
6.86
2.50
OF HANDLE
ESCUTCHEON
DRILL AND TAP
1/4-20 HOLE
(4 OR 6 PLS.)
REQUIRED FOR
SCJD6/SCLD6
ONL Y
Fig. 2
MANUAL OPERATION
Manual operation of the circuit breaker is con-
trolled by the circuit breaker handle and the
PUSH-TO-TRIP button. The circuit breaker
handle has three indicating positions, two of
which are molded into the handle to indicate
ON and OFF. The third position indicates a
TRIP position and is between the ON and OFF
positions. (See Fig. 4)
3.00
1.50
3.07
1.50
2.00
3.25
OF HANDLE
ESCUTCHEON
(SEE FIG. 2)
6.50
Fig. 3
Hazardous voltage.
Will cause death or
severe injury.
Turn off and lock out all power
supplying this device before
removing cover(s) or device and
while cover(s) are removed.
Replace all covers and shields
before power supplying this device
is turned on.
OF HANDLE
ESCUTCHEON
(SEE FIG. 2)
Advertisement
