Canon W2200 User Manual page 75

Menu Item
Paper Adjust
Plain Paper, Coated Paper, Photo
Pro, Glossy Paper, Glossy Paper 2,
Matte Photo, Glossy Film, Quick
Dry Tran, Transparency, Special 1
~ ~
Special 5, Proof A Proof D
Set Interface
Interface Type
Set Centronics
Trans. Speed
Interactive
Ext. Network
Init. Settings
Set TCP/IP
Regis. Settings
Maint. Setup
Cleaning at ON
Panel Reset
Panel Reset
*1. If the date and time setting of the computer where the printer is connected are
not correct, the printhead may clean itself too frequently and waste ink. Make
sure that all the date and time settings on the computer are correct.
Available Settings
Print Pattern A, Print Pattern B,
Adj. Setting
~ ~
:-28 0* +28
Centronics, USB*
High Speed*, Medium Speed,
Low Speed
ECP*, Nibble, None
Frame Type: Disable, Ethernet II
IP Mode: Manual*, Automatic
Protocol
DHCP: On*, Off
BOOTP: On*, Off
RARP: On*, Off
IP Setting
IP Address
Subnet Mask
Default G/W
On*, Off
Functions
Use this menu to adjust the amount
of feed for type of the media. If the
printed image of "Pattern A" has
white streaks or dark streaks, set the
adjustment value. For fine
adjustment, print "Pattern B" and
select the adjustment value.
Allows selection Centronics for a
parallel interface connection or USB
for a USB connection.
Allow selections for speed and
format of bi-directional printing. A
hard reset must be performed on the
printer to enable these settings.
Executes the initial settings for the
"Ext. Network" menu.
Allows selections to set up the TCP/
IP network information for the
network interface board. After
selecting a setting for each TCP/IP
item, execute "Regis. Settings" to
enable the values selected.
Registers the TCP/IP settings
selected above for the network
interface board.
Determines whether or not the
printhead is cleaned when the printer
*1
is powered on.
Initializes the operation panel menus
and restores the default settings. A
panel reset does not affect the "Ext.
Network" settings.
Menu Settings Summary Tables
5-13