Carrying-In - Toshiba V Series User Manual

3.2.5

Carrying-in

Normally, carry equipment into the control room after unpacking. Carry equipment
carefully so as not to give shock or damage to the equipment.
(1) Carry equipment on a hand truck or using steel pipes as rollers. Lay blockboards
etc. on the floor, for protection.
(2) If a lever is to be used, apply pads to the equipment for protection against damage.
(3) When carrying tall equipment, pay attention to the center of balance so that the
equipment does not turn over.
(4) When carrying equipment into the control room, take appropriate measures to
minimize difference between outdoor and indoor temperatures so that dews are not
formed on the interior or exterior surfaces of the console.
6F8C0882
1800mm
800mm
Required height:
Height of console + Height of
carrying device
1500 mm min.
For train of three consoles
Figure 3-4 Dimensions of Carry-in Entrance and Passage (Example)
D = 750 mm
or 800 mm
H = 1250 mm
or 1950 mm
Blockboard etc.
Figure 3-5 Carrying Method
3.2 Carrying-in & Installation
800mm
600mm
Required height:
Height of console + Height
1000 mm min.
of carrying device
For a single console
W = 600 mm
or 800 mm
Hand truck
3
47