Error Displays/Messages - Sony CDX-DAB700U Operating Instructions Manual

Error displays/Messages

CHECKING
 The unit is confirming the connection of a
USB device.
– Wait until confirming the connection is
finished.
ERROR
 The disc is dirty or inserted upside down.
– Clean or insert the disc correctly.
 A blank disc has been inserted.
 The disc cannot play due to a problem.
– Insert another disc.
 USB device was not automatically recognized.
– Reconnect it again.
 Press  to remove the disc.
FAILURE
 The connection of speakers/amplifiers is
incorrect.
– See the installation/connections manual of
this model to check the connection.
HUBS NO SUPRT (Hubs Not Supported)
 USB hub is not supported on this unit.
INVALID
 The connected USB device does not contain a
music file for the SensMe™ function.
NO AF (No Alternative Frequencies)
 There is no alternative frequency for the
current station.
– Press  +/– while the program service
name is flashing. The unit starts searching
for another frequency with the same PI
(Program Identification) data ("PI SEEK"
appears).
NO CHANNEL
 The connected USB device does not contain a
channel list for the SensMe™ function.
NO DATA
 There is no program type for the current DAB
service.
– Press
34
(BACK).
NO DEV (No Device)
 USB is selected as source without a USB device
connected. A USB device or a USB cable has
been disconnected during playback.
– Be sure to connect a USB device and USB
cable.
NO INFO (No Information)
 There is no label information for the current
DAB service.
NO MUSIC
 The disc or USB device does not contain a
music file.
– Insert a music CD in this unit.
– Connect a USB device with a music file in it.
NO NAME
 A disc/album/artist/track name is not written
in the track.
 There is no ensemble/service name for the
current DAB service.
NO SERVICE
The DAB signal cannot be received.
 Perform an auto scan (page 10).
 Check the connection of the DAB antenna
(aerial).
 Check that "ANT-POWER" is set to "ON"
(page 27).
NO TP (No Traffic Programs)
 The unit will continue searching for available
TP stations.
NOT FOUND
 There is no item beginning with the selected
letter in Alphabet search.
OFFSET
 There may be an internal malfunction.
– Check the connection. If the error indication
remains on in the display, consult your
nearest Sony dealer.
OVERLOAD
 USB device is overloaded.
– Disconnect the USB device, then change the
source by pressing .
– Indicates that the USB device is out of order,
or an unsupported device is connected.