Preparing the card remote
Remove the insulation film.
For how to replace the battery, page 25.
Setting the clock
The clock uses a 24-hour digital indication.
Press and hold the select button.
The setup display appears.
Press the select button repeatedly
until "CLOCK-ADJ" appears.
Press (SEEK) +.
The hour indication flashes.
Rotate the control dial to set the hour
To move the digital indication, press (SEEK)
After setting the minute, press the
The setup is complete and the clock starts.
To display the clock, press (DSPL). Press
(DSPL) again to return to the previous display.
You can set the clock automatically with the RDS
feature (page 15).
Detaching the front panel
You can detach the front panel of this unit to
If you turn the ignition switch to the OFF
position without detaching the front panel, the
caution alarm will sound for a few seconds.
The alarm will only sound if the built-in
amplifier is used.
The unit is turned off.
, then pull it off towards you.
• Do not drop or put excessive pressure on the front
panel and display window.
• Do not subject the front panel to heat/high
temperature or moisture. Avoid leaving it in a parked
car or on a dashboard/rear tray.