Messages - Sony MHC-EC68USB Operating Instructions Manual

Messages

General
PROTECT: The following causes can be
considered:
 The voltage selector may not be
set to the correct local power line
voltage.
 Speaker cords may be short-
circuited.
 The ventilation holes may be
blocked.
See "If "PROTECT" appears on the
display" (page 26) to check what to do
if this message appears.
CD/MP3 player, Tuner
LOCKED: The disc tray does not open.
Contact your nearest Sony dealer.
NO STEP: All of the programmed tracks
have been erased.
TIME NG: The Play Timer or start and
end times are set to the same time.
OVER: You have reached the end of the
disc while pressing 
playback or pause.
PUSH SELECT: Select "PLAY SELECT. "
PUSH STOP: Stop playback, then select
the play mode.
READING: The system is reading
information of the disc. Some buttons
are not available.
FULL: You tried to program more than
26 tracks or files (steps).
USB device
DATA ERROR: You tried to play a file that
DEVICE ERROR: The USB device could
FATAL ERROR: The USB device was
NO STEP: All of the programmed tracks
NO SUPPORT: An unsupported USB
NO TRACK: No playable file is loaded in
NOT USED: You tried to perform a
OVER CURRENT: An over current was
PROTECTED: The USB device is write-
PUSH STOP: You tried to perform an

during
READING: The system is reading
REC ERROR: Recording did not start,
REMOVED: The USB device has been
FULL: You tried to program more than
is not playable.
not be recognized or an unknown
device is connected (page 29).
removed during recording or erase
operation, and may have been
damaged.
or files have been erased.
device is connected, or the USB device
is connected to this system through
a hub.
the system.
specific operation under conditions
where that operation is prohibited.
detected.
protected.
operation that can be performed only
when the system is stopped.
information of the USB device. Some
buttons are not available.
stopped partway, or otherwise could
not be performed (page 27).
removed.
26 tracks or files (steps).
1
GB