Getting Started; Unpacking; Hooking Up The System - Sony CDP-XE330 Operating Instructions Manual

Getting Started

Unpacking

Check that you received the following items:
• Audio connecting cord (1)
• Remote commander (remote) (1)
• R6 (size AA) batteries (2)
Inserting batteries into the remote
You can control the player using the supplied remote.
Insert two R6 (size AA) batteries by matching the + and
– on the batteries to the diagram inside the battery
compartment.
Insert the negative (–) end first, then push in and down
until the positive (+) end clicks into position.
When using the remote, point it at the remote sensor g
on the player.
When to replace batteries
With normal use, the batteries should last for about six
months. When the remote no longer operates the player,
replace all the batteries with new ones.
Notes
• Do not leave the remote near an extremely hot or humid
place.
• Do not drop any foreign object into the remote casing,
particularly when replacing the batteries.
• Do not expose the remote sensor to direct sunlight or
lighting apparatuses. Doing so may cause a malfunction.
• If you don't use the remote for an extended period of time,
remove the batteries to avoid possible damage from battery
leakage and corrosion.
4 GB

Hooking Up the System

Overview
This section describes how to hook up the CD player to
an amplifier. Be sure to turn off the power of each
component before making the connections.
LINE OUT LINE OUT
(R) (L)
Audio input Audio input
(L) (R)
: Signal flow
What cords will I need?
Audio cord (supplied) (1)
White
(L)
Red
(R)
Hookups
When connecting an audio cord, be sure to match the
colour-coded cord to the appropriate jacks on the
components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
CD player
LINE
OUT
L
R
CD player
To mains
Amplifier
To mains
White
(L)
Red
(R)
Amplifier
INPUT
CD
L
R