Setting The Roll Media - Canon W7200 Setup Manual

7 Setting the Roll Media

Loading the roll media requires two procedures:
•
•
The types of roll media that can be loaded onto the roll holder are listed in
the table below. You must select the correct roll media type setting to match
the type of roll media loaded.
Plain Paper
Coated Paper
Heavy Coated Paper
Glossy Paper
Photo Glossy Paper
Photo Semi-Glossy Paper
Glossy Film
Back Print Film
Proofing Paper
Note
z Before the printer is shipped from the factory, the Roll Media Type is set for Plain
Paper.
z It is recommended that the special settings (1 to 5) be used when smudges and
blots appear on the print density is too light while printing on one of the media
types listed above. The Special settings determine in 5 steps the amount of ink used
on the surface of the media. The higher the number in the range of 1 to 5, the
greater the amount of ink used. The setting may require testing and adjustment,
depending on the media in use and the content of the image.
z The media size is detected automatically, therefore no setting for the size is
required.
Setting the roll media on the roll holder.
Setting the roll media type with the operation panel.
Media Name
—
Roll Media Type Setting
Plain Paper
Coated Paper
Heavy Coated
Glossy Paper
Photo Glossy
Photo Semi-Glos
Glossy Film
Back Print Film
Proof
Special 1 to 5
7 Setting the Roll Media
1-31