Download  Print this page

Canon Laser Shot LBP-1110 User Manual Page 9

Canon laser beam printer user's guide.
Hide thumbs


❏ 100–127 V model only:
This product is equipped with a 3-wire grounding type plug, a plug
that has a third (grounding) pin. As a safety feature, this plug fits only
into a grounding-type power outlet. If you are unable to insert the plug
into the outlet, contact an electrician to replace your obsolete outlet.
Do not defeat the purpose of the grounding-type plug.
❏ 220–240 V model only:
A certified power supply cord is to be used with this equipment. For a
rated current up to 6 A, a type not lighter than H05VV-F 3G 0.75 mm
or H05VVH2-F 3G 0.75 mm
❏ Be sure to turn off the power before unplugging or plugging in the
printer power cord or interface cable.
❏ When moving the printer, be sure to turn off the power before
unplugging the power cord.
❏ Be sure to unravel the power cord prior to plugging it in; otherwise it
may lead to damage, overheating, short-circuit, or result in fire.
❏ Be sure to plug the power cord firmly into the power outlet, as any
flammable material caught between an opening might result in fire.
❏ Avoid using an extension cord. If you must use an extension cord, be
sure to take the following precautions. Failure to do this might lead to
overheating, result in fire, or cause flickering due to a drop in voltage.
• Be sure not to exceed the allowed rating current of the extension
• Use a short extension cord. Do not connect several extension cords
• Make sure that the total ampere rating of the products plugged into
❏ Slots and openings in the cabinet are provided for ventilation. To
ensure reliable operation of the printer and to protect it from
overheating, these openings must not be blocked or covered. The
openings should never be blocked by placing the printer on a bed,
sofa, shag rug, or other similar surface.
the extension cord does not exceed the extension cord ampere
shall be used.


Table of Contents

   Related Manuals for Canon Laser Shot LBP-1110

Comments to this Manuals

Symbols: 0
Latest comments: