Installing the CAPT
If you are using the LBP-810 as a local printer (connected directly to your
computer) follow the steps below. If the LBP-810 is already on your
network, and you want to start using it, follow the steps in "Connecting
to the LBP-810 Already on Your Network" on pag e 58. If you want to
install the LBP-810 as a network printer, follow the steps in "Connecting
the LBP-810 as a Network Printer" on pag e 62.
For installation instructions using the CD-ROM menu, please see the
Getting Started Guide.
Plug and Play
Following is the installation procedure of plug and play for "Using USB
and Parallel Port" under Windows 95/98/Me.
Before you install the software, make sure you do the following:
❏ Start Windows 95, 98 or Me.
❏ Connect the printer to your computer (For details, see the Getting
❏ Turn on the printer (For details, see the Getting Started Guide).
If you are using Windows 95 OSR2.1 or later, an error may occur while
trying to install using plug and play. If you get an error, install the
software using the CD-ROM. To check which version of Windows 95 you
are using, open the system window in Control Panel and look at the
version number in the General tab. 4.00.950 B or 4.00.950 C means you
are using OSR2.1 or later.
Using USB Port (USB Cable)
In order to use the printer via USB, the following requirements need to be
❏ Your computer must be equipped with a USB port and it is necessary
that its operation is approved by the manufacturer.
❏ Windows 95 is not available for USB.
Using the Canon Advanced Printing Technology