Logging Out - Canon IR C2100 Job Management Manual

2
2-5 Starting up and logging in
When you reopen the slider after you have logged in, the Log in button will
have changed to the Log out button.
Access levels
The three possible levels of access to Command WorkStation functions are
Administrator, Operator, and Guest. To enable maximum password
protection, Administrator and Operator passwords must be specified in Setup
(see the Configuration Guide).
When both Administrator and Operator passwords have been specified, the
access levels are as follows:
Access level:
Administrator
Operator
Guest
Access privileges alone do not confer control of print jobs. If the
N :
OTE
operator is going to manage all print jobs, the Administrator must route all
user jobs to the Hold queue (that is, all jobs are spooled and held on the
iR C2100/2100S). To accomplish this, only the Hold queue, and not the
Direct connection or the Print queue, should be enabled in Setup. See the
Configuration Guide for more information.

Logging out

There are two ways to log out from the iR C2100/2100S:
• From the Server menu, choose Log out.
• Open the log in/out slider (click the key icon just below the Fiery logo)
and click Log out.
Privileges and password requirements:
Has full access to all Command WorkStation and
iR C2100/2100S Control Panel functions;
Administrator password required.
Has access to all Command WorkStation functions
except Setup, Calibration, clearing the iR C2100/2100S
disk, clearing the Job Log, and font management;
Operator password required.
Can view job status, but cannot make changes to jobs or
Setup, and can view the Queues window only; no
password required.