Bissell 1623 SERIES 1623 SERIES User Manual page 5

A
ssembly
Your deep cleaner comes in five easy to
assemble components:
• Handle assembly
• Upper body assembly
• Upper hose rack
• Lower body assembly
• Lower hose rack
Three Phillips head screws are included and can
be found taped to the handle assembly.
The only tool you will need to assemble your
cleaner is a Phillips head screwdriver.
1. Slide upper body assembly onto lower
body and secure with two screws.
2. With the "tabs" on upper hose rack
pointing toward top of handle, attach upper
hose rack to handle assembly by sliding it
to top of handle until it can go no further.
Turn hose rack until it snaps into place.
3. Slide handle assembly down into upper body
until it will go no further and secure with screw.
4. Attach lower hose rack to back of upper
body by pushing into open slots and sliding
down until it snaps into place.
5. Wrap flex hose around hose rack and
secure it into notched out holder as
shown.
6. Keep flex hose locked in place with hose
secure latch.
w w w . b i s s e l l . c o m w w w . b i s s e l l . c o m
WARNING:
Do not plug in your cleaner
until you have completely
assembled it per the
following instructions
and are familiar with all
instructions and operating
procedures.
1.
2.
Tab
3.
4.
5.
Hose
Secure
Latch
Notch
8 0 0 . 2 3 7 . 7 6 9 1 8 0 0 . 2 3 7 . 7 6 9 1
Upper Hose Rack
6.
16 5