Advertisement
Avanti I - Assembly Instructions continued - Page 3 of 3
Step 9.
Slide one of the [3] Top Canvas Supports [part #11] over
top end of Center Column [part #8]. Secure by screwing
knob [part # 10] into Top Canvas Support. Repeat with 2nd
Top Canvas Support. This time slide it down upside down
(see FIG H) secure with knob, finish by sliding the third Top
Canvas Support over the top of the center column. Secure
with Knob. These Knob allow for adjustment of Top Canvas
Supports. Too adjust height, loosen Knob and slide Top
Canvas Support up or down Upper Center Column. When
desired height is achieved, re-tighten knob until secure.
See FIG H. NOTE: Do Not Over-tighten Knobs, this will
mar the surface of the chrome.
Step 10.
Easel should now look like FIG I.
ADJUSTING TILT
To adjust Tilt - loosen KNOB-A and adjust to desired tilt.
Re-tighten Knob. NOTE: Do Not Over-tighten Knobs,
this will mar the surface of the chrome.
ADJUSTING HEIGHT OF EASEL & LARGE SUPPLY
TRAY
To adjust height of Easel, loosen KNOB-B and move upper
column to desired height. Re-tighten Knob.
PLEASE NOTE:
This will also raise or lower the Large Supply Tray.
NOTE: Do Not Over-tighten Knobs, this will mar
the surface of the chrome.
ADJUSTING TOP CANVAS SUPPORTS
To adjust one, two or three of the Top Canvas Supports,
loosen KNOBS-C and move to desired location.
Re-Tighten Knob.
NOTE: Do Not Over-tighten Knobs, this will mar
the surface of the chrome.
4444 Lawton Avenue, Detroit MI 48208 USA
Tel:(313)895-0700 • Fax:(313)895-0709
E-mail: Custservmud@aol.com
Visit us at: www.MartinUniversalDesign.com
FIG H
10
8
This one 2nd
10
This one first
10
FIG I
C
C
C
B
A
11
This one 3rd
11
11
pg 3
Advertisement
