Advertisement
Avanti I - Assembly Instructions continued - Page 2 of 3
Step 3.
Continue by sliding the T-Support [part #4] over the chrome
joiner [part #3]. Continue by taking the left leg [part #1] and
connect to both ends of the chrome tube and joiner.
See FIG C.
Step 4.
Secure T-Support by attaching two allen screws [part #7]
to the left and right sides of the T-Support in the threaded
holes using Allen Wrench supplied [part #13].
See FIG D.
Step 5.
Complete base assembly by turning it over and threading
in the [4] feet [part # 12] into each of the 4 holes on base
bottom. See FIG E.PLEASE NOTE: The hole that is on
the top surface of each leg is for the
Optional Accessory Tab Tray. (Sold Separately).
Step 6.
Insert Center Column [part #8] through tilt support [part #6]
and into T-Support [part # 4]. Secure at T-Support with Allen
Screw [part # 7]. Attach knob [part #11] to Tilt-Support. This
Knob allows adjustment for the Tilt of the Easel.
See FIG F. NOTE: Do Not Over-tighten Knobs, this will
mar the surface of the chrome.
Step 7.
From top of center column [part #9] slide Large Supply
Tray [part #10] over center column. Secure by attaching
knob [part # 11]. This Knob allows to adjust the height of
the Large Supply Tray. See FIG G.
NOTE: Do Not Over-tighten Knobs, this will mar the
surface of the chrome.
FIG C
3
1
FIG D
7
1
8
11
7
8
9
4
13
4
FIG E
12
FIG F
6
4
FIG G
11
pg 2
Advertisement
