Changing The Program; Cancelling A Program; Laundry Addition Function; End Of The Program - Beko 2012 CX Owner's Manual

Changing the Program

Even if a new program is selected by
changing the position of program selection
knob while your machine is operating, the
first selected program continues to run.
In order to change the washing program,
the ongoing program should be cancelled.
(See. Cancelling a program)
In order to change the auxiliary functions
while your machine is operating, you can
make any desired changes after pressing
the "Start/Pause/Cancel" button.
If you want to change the spin speed
while your machine is operating, press the
"Start/Pause/Cancel" button, select the
spin speed and press the "Start/Pause/
Cancel" button again.

Laundry Addition Function

If you want to add laundry to your machine
after the washing program starts, switch
the machine to pause mode by pressing
"Start/Pause/Cancel" button. If the water
level in the machine is suitable, the "Door"
light on the program follow-up indicator
comes on approximately 2 minutes later
and you can open the door and add
laundry. If the "Door" light is not
continuously on at the end of this period,
the water level in the machine is not
suitable and you can not add laundry.
You can resume the program by pressing
"Start/Pause/Cancel" button again.

Cancelling a program

In order to cancel the selected program,
"Start/Pause/Cancel" button is pressed for
3 seconds and machine starts to drain at
the end of this time. Meanwhile, "Washing"
and "End" lights are on. After the drainage
process completes "Start/Pause/Cancel"
and "Washing" lights are off. "Door" light
starts to flash. When the "Door" light is
on continuously, the door can be opened
and a new program can be selected. You
can start a program by selecting a new
program.
The selected program continues to run
even if the position of program selection
knob is changed while your machine is
operating. In order to change the washing
program, a new program can be selected
and started after "Cancelling a program"
by pressing the "Start/Pause/Cancel"
button for 3 seconds as described above.

End of the Program

When the program ends "End" light on the
program follow-up indicator comes on.
"End" and "Door" lights come on within
two minutes after the door is opened,
the machine becomes ready for the next
washing. If any of the buttons is pressed
or the position of the selection knob is
changed when the machine is at the end
of a program, "End" light goes off and only
the "Door" light remains on. Meanwhile,
if the door is still locked, the "Door" light
flashes until the door is opened. To turn
the machine off, press the "On/Off" button.

Unloading the Laundries

Your machine stops automatically when
the program ends. Turn off the taps. Grab
and pull the handle to open the door.
Press "On/Off" button to turn off your
machine. After you take the laundries out,
leave the front door open and ventilate the
inside of the machine. Check the inside of
the bellows and wipe it.
13
EN